.. _flash_documentation-supported_hardware: Supported Hardware ================== The devices listed here have been tested. More devices using the same drivers will likely also function correctly, but this has not been verified. **Cameras**: +++++++++++++++++++++++++++++++++++++++++++++++++++++ - Hamamatsu sCMOS: Flash 4.0 v2 (C11440-22CU), Flash 4.0 v3 (C13440-20CU), Fusion (C14440-20UP), Fusion-BT (C15440-20UP), and Quest (C15550-20UP). - Photometrics: Kinetix (01-KINETIX-M-C) **Microscope stand** +++++++++++++++++++++++++++++++++++++++++++++++++++++ - Nikon Eclipse Ti2-E **Stage controller** +++++++++++++++++++++++++++++++++++++++++++++++++++++ - Nikon Eclipse Ti2 motorized encoder stage (TI2‑S‑SE‑E) - Newport ESP300/301/302 (tested with LTA-HS motors). *Must be connected by USB.* - ASI controllers (tested with MS-2000 stage) - Must be connected by serial port (RS232) with 9600 baud rate. - Ludl MAC5000 or MAC6000 controller (tested with BioPrecision2 stage). - Must be connected by serial port (RS232) with 9600 baud rate. **DAQ** (for triggering shutters and cameras) ++++++++++++++++++++++++++++++++++++++++++++++++++++ - Arduino Due programmed with the `Microsync `_ firmware. - Arduino MEGA 2560 programmed with the firmware provided in a `legacy project `_. - National Instruments USB-6501. We recommend against this option because the timing jitter is significantly worse than using an external device. **Laser power control** ++++++++++++++++++++++++++++++++++++++++++++++++++++ - LaserQuantum: Opus, Ventus, and Gem (RS232 interface). - Coherent: HOPS (Genesis line) and OBIS series. Only one such laser may be connected. - Thorlabs: PRM1Z8 motorized rotation stage (for laser power attenuation). Only one such device may be connected. - Cobolt: experimental support (untested). - **Power meter** - Newport 1919-R (RS232 connection) - Thorlabs PM16-121 (others probably work but have not been tested) **Autosampler** +++++++++++++++++++++++++++++++++++++++++++++++++++++ - SIELC Alltesta (7/6 valve, 120 uL syringe, 96-well plate)